Advantage 67xx Error Codes
Advantage Error Guide
Contents
6701 An illegal buffer length was supplied 6703 An illegal command was supplied 6705 The command timed out 6706 A message was incomplete. The application needs to issue another command 6707 The buffer address specified was illegal 6708 The session number specified was out of range 6709 No resource was available 6710 The session was closed. ADSDOSIP shut down communications with the CA-Clipper application 6711 The command was canceled 6713 A duplicate name existed in the local name table 6714 The name table was full 6715 The command finished, however, the name has active sessions and is no longer registered 6717 The local session table was full 6718 The remote session table was full, therefore the request to open a session was rejected 6719 An illegal name number was specified 6720 The system did not find the name that was called 6721 A * is not permitted in the ncb_name member 6722 The name was already in use on the remote adapter 6723 The name was deleted 6724 The session ended abnormally 6725 A name conflict was detected 6733 The interface was busy. IRET before retrying 6734 Too many commands were outstanding. The application can retry the command later 6735 The ncb_lana_num member did not specify a valid network number 6736 The command finished while a cancel operation was occurring 6738 The NCBCANCEL command was not valid, therefore the command was not canceled 6748 The name specified was defined by another local process 6752 The environment was not defined. A reset command must be issued 6753 System resources were exhausted. The application can retry the command later 6754 The maximum number of applications was exceeded 6755 Service access points (SAPs) were unavailable for NetBIOS 6756 The requested resources were not available 6757 The NCB address was invalid 6759 The NCB DDID was invalid 6760 The attempt to lock the user area failed 6763 An error occurred during an open operation being performed by the device driver 6764 A system error occurred 6770 The read received data that was too large 6771 The packet had a bad header 6772 The packet had bad data
6701 An illegal buffer length was supplied
6703 An illegal command was supplied
6705 The command timed out
6706 A message was incomplete. The application needs to issue another command
6707 The buffer address specified was illegal
6708 The session number specified was out of range
6709 No resource was available
6710 The session was closed. ADSDOSIP shut down communications with the CA-Clipper application
6711 The command was canceled
6713 A duplicate name existed in the local name table
6714 The name table was full
6715 The command finished, however, the name has active sessions and is no longer registered
6717 The local session table was full
6718 The remote session table was full, therefore the request to open a session was rejected
6719 An illegal name number was specified
6720 The system did not find the name that was called
6721 A * is not permitted in the ncb_name member
6722 The name was already in use on the remote adapter
6723 The name was deleted
6724 The session ended abnormally
6725 A name conflict was detected
6733 The interface was busy. IRET before retrying
6734 Too many commands were outstanding. The application can retry the command later
6735 The ncb_lana_num member did not specify a valid network number
The problem may result because NetBIOS is not installed or ADSDOSIP ran more than once.
Note Microsoft TCP/IP protocol does provide NetBIOS.
6736 The command finished while a cancel operation was occurring
6738 The NCBCANCEL command was not valid, therefore the command was not canceled
6748 The name specified was defined by another local process
6752 The environment was not defined. A reset command must be issued
6753 System resources were exhausted. The application can retry the command later
6754 The maximum number of applications was exceeded
6755 Service access points (SAPs) were unavailable for NetBIOS
6756 The requested resources were not available
6757 The NCB address was invalid
6759 The NCB DDID was invalid
6760 The attempt to lock the user area failed
6763 An error occurred during an open operation being performed by the device driver
This return code is not part of the IBM NetBIOS 3.0 specification.